Inkheads

From College of Art and Design IT Wiki
Revision as of 16:14, 1 November 2017 by TJ (talk | contribs) (Created page with "= Inserting Inkheads = <ul><ol> <li>Remove the orange protective caps by pulling them down.</li> Figure 1: Removing the protective caps from the printhead File:RemoveProt...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Inserting Inkheads

    1. Remove the orange protective caps by pulling them down.
    2. Figure 1: Removing the protective caps from the printhead

      RemoveProtectiveCaps.png

    3. The printhead is designed to prevent you from accidentally inserting it into the wrong slot. Check that the colored label on the printhead matches the colored label of the carriage slot into which the printhead is to be inserted.
    4. Insert the new printhead into its correct slot in the carriage.
    5.   CAUTION: Insert the printhead slowly and vertically, straight down. It can be damaged if you insert it too quickly, or at an angle, or if you rotate it as you insert it.
      

      Figure 2: Inserting the printhead

      InsertPrinthead.png

    6. Push down as indicated by the arrow.
    7. Figure 3: Pushing in the printhead

      PushInPrinthead.png

        CAUTION: You might feel some resistance when installing the new printhead, so you need to press it down firmly but smoothly. You should hear a beep and see confirmation on the front-panel display that the printhead has been inserted
      
    8. Insert all of the other printheads that need to be installed, and close the carriage cover.
    9. Figure 4: Closing the carriage cover

      CloseCarriageCover.png

    10. Make sure that the end of the blue handle catches the wire loop on the near side of the carriage.
    11. Figure 5: Closing the carriage cover, step 2

      CloseCarriageCover2.png

    12. Lower the handle to rest on the carriage cover.
    13. Figure 6: Closing the cover, step 3

      CloseCarriageCover3.png

      When all of the printheads have been inserted correctly and the printer has accepted them, the printer beeps.

        NOTE: If the printer does not beep when you insert the printhead and the Replace message appears on the front-panel display, you might need to reinsert the printhead.
      
    14. Close the printer window.
    15. Figure 7: Closing the printer window

      ClosePrinterWindow.png

    16. The front-panel display confirms that all of the printheads are correctly inserted. The printer starts checking and preparing the printheads. The default routine process, when all printheads are changed, takes about 18 minutes. If the printer identifies a problem when preparing the printheads, the process takes longer, up to 30 minutes. For a single printhead insertion, the time varies between 10 and 20 minutes. After all printheads are checked and prepared, the printhead realignment procedure runs automatically if paper is loaded.